Gravity casting double kingpin trucks on Backfire Ranger X2 electric skateboard

Author: Backfire Boards via YouTube
Go to Source
Gravity casting double kingpin trucks on Backfire Ranger X2 electric skateboard

In this video we will introduce you the truck design and cornering performance of the ranger x2.
The Ranger x2 uses the same double kingpin trucks as the x1
The advantage of this structure is that you can enjoy the smoothness of carving on the road, meanwhile the turning circle is very small, the turning is also very precise & planted…
Backfire’s double kingpin trucks uses gravity casting, which is six times stronger than most press castings on the market, the middle steel shaft size is 9.5mm, that’s (XXX) which is much stronger than the 7.9mm, that’s (XXX) steel shaft of other brackets.
After many professional skaters’ tests and suggestions, we have improved the material and shape of the entire suspension, which greatly improved the dynamic of carving.
Learn more https://www.backfireboards.com/ranger-x2
⚡️ RECOMMENDED FOR BACKFIRE RIDER

Night Lights Backfire Cannon: https://bit.ly/33cUX50
Backfire 风林火山T-shirt: https://bit.ly/2OG1rGy

❓ FAQ

Where is board ship from?
Boards in the EU ship from depo in Hamburg, Germany but sales support and customer service is in Windermere in the UK. Boards in the USA ship from our LA office and they also deal with service and support. Our main manufacturing and development office is in the Shenzhen region of China.

How do I pair the remote with the board?
Check this link: https://youtu.be/pzyxVNpRsm8

Can Backfire be used like a normal skateboard when it’s out of power?
Yes, our boards are totally push friendly and will ride like a traditional skateboard when not on the throttle or when there is no battery.

Is my Backfire board waterproof?
The waterproof level of Backfire boards is IP55.
Riding over small puddles will not damage the board, nor will riding in light rain, however never submerge the board in the water and stop riding if the conditions lead to standing water on roads or track.
When you have finished riding in wet conditions it’s important to dry the board off with a rag and then spin the wheels using the motor and remote for two minutes to remove any access water. If the board did go through deeper standing water it may be a good idea to remove the outer case and gentle towel dry any visible water and then leave the board in a warm dry place.
Never leave a wet board upside down in the damp or this can cause the water to bypass the seal and ingress into the electronics. Your remote should also be kept dry and warm after use in the rain.

More questions please check here
https://www.backfireboards.com/pages/faq

Go to Source