How to install the handle and front lights on Backfire Hammer

Video by Backfire Boards via YouTube
Source
How to install the handle and front lights on Backfire Hammer

Get a Backfire Hammer here
https://www.backfireboards.com/products/backfire-hammer-belt-drive-all-terrain-electric-skateboard

⚡️ RECOMMENDED FOR BACKFIRE RIDER

Night Lights Backfire Cannon: https://www.backfireboards.com/collections/electric-skateboard-accessories/products/backfire-cannon-ii-electric-skateboard-lights
Backfire 风林火山T-shirt: https://bit.ly/2OG1rGy

❓ FAQ

Where is board ship from?
Boards in the EU ship from depo in Hamburg, Germany and Boards in the USA ship from our LA office and they also deal with service and support. Our main manufacturing and development office is in the Shenzhen region of China.

How do I pair the remote with the board?
Check this link: https://youtu.be/pzyxVNpRsm8

Can Backfire be used like a normal skateboard when it’s out of power?
Yes, our boards are totally push friendly and will ride like a traditional skateboard when not on the throttle or when there is no battery.

Is my Backfire board waterproof?
The waterproof level of Backfire boards is IP55.
Riding over small puddles will not damage the board, nor will riding in light rain, however never submerge the board in the water and stop riding if the conditions lead to standing water on roads or track.
When you have finished riding in wet conditions it’s important to dry the board off with a rag and then spin the wheels using the motor and remote for two minutes to remove any access water. If the board did go through deeper standing water it may be a good idea to remove the outer case and gentle towel dry any visible water and then leave the board in a warm dry place.
Never leave a wet board upside down in the damp or this can cause the water to bypass the seal and ingress into the electronics. Your remote should also be kept dry and warm after use in the rain.

More questions please check here
https://www.backfireboards.com/pages/faq

Go to Source