Video by Backfire Boards via YouTube
Source
Get a Backfire Hammer here
https://www.backfireboards.com/products/backfire-hammer-belt-drive-all-terrain-electric-skateboard
The Backfire Hammer has a large number of optional accessories
This is a mudguard, which can be mounted to the Ranger series and also The Hammer, so that you will not get your whole body dirty & wet, when you are riding on slightly watery roads. This is not a standard accessory, you will need to buy it, at www.backfireboards.com
Here is the Backfire Cannon headlamp, which can be installed on the top of the Ranger series and also The Hammer, it has an incredibly long reach, so, very convenient, confidence inspiring, for night riding..
This is a nose handle…… It’s super practical for you to drag the skateboard, on just x2 wheels…
By the way, look at this cool bash guard, which is standard for all Hammers, and comes free with the board.
⚡️ RECOMMENDED FOR BACKFIRE RIDER
Night Lights Backfire Cannon: https://www.backfireboards.com/collections/electric-skateboard-accessories/products/backfire-cannon-ii-electric-skateboard-lights
Backfire 风林火山T-shirt: https://bit.ly/2OG1rGy
❓ FAQ
Where is board ship from?
Boards in the EU ship from depo in Hamburg, Germany and Boards in the USA ship from our LA office and they also deal with service and support. Our main manufacturing and development office is in the Shenzhen region of China.
How do I pair the remote with the board?
Check this link: https://youtu.be/pzyxVNpRsm8
Can Backfire be used like a normal skateboard when it’s out of power?
Yes, our boards are totally push friendly and will ride like a traditional skateboard when not on the throttle or when there is no battery.
Is my Backfire board waterproof?
The waterproof level of Backfire boards is IP55.
Riding over small puddles will not damage the board, nor will riding in light rain, however never submerge the board in the water and stop riding if the conditions lead to standing water on roads or track.
When you have finished riding in wet conditions it’s important to dry the board off with a rag and then spin the wheels using the motor and remote for two minutes to remove any access water. If the board did go through deeper standing water it may be a good idea to remove the outer case and gentle towel dry any visible water and then leave the board in a warm dry place.
Never leave a wet board upside down in the damp or this can cause the water to bypass the seal and ingress into the electronics. Your remote should also be kept dry and warm after use in the rain.
More questions please check here
https://www.backfireboards.com/pages/faq