Video by Lacroix Adventures via YouTube
Source
The design brief was a heavy one; make a gear drive that is easy to adjust, very quiet and also looks great. We did a few iterations to improve the performance. Here’s how to make the changes and install the Falcon Gear Drive
Introduction
00:25 : Explanation of the major difference between V1 and V2
01:07 : Tools needed
– 19 mm socket
– 22 mm socket
– 2 1/2 mm, 3mm, 4mm, 6mm Allen keys
– 4mm screw drive
– Small electric drill (optional) with 2 1/2 and 3 mm bit
– Loctite Red 271
– Loctite 680
– Lithium based grease
02:21 : Parts included
03:27 : Removing the old short axles to install the long one
04:11 : Installing the long axles
04:54 : Installing the motor plates
06:01 : Installing the O’ring
06:43 : Installing the 59 teeth Pom Gear
07:58 : Installing the motor disc on the motors
08:15 ** m4 16mm screws (and not keys) **
09:00 : Installing the motors on the plate and the elliptic rings
12:04 : Installing the 14 teeth pulley
12:46 : Putting back the Pom Gear on the axles
13:17 : Adjusting the backlash
15:54 : Applying Grease on the Falcon gear Drive
16 :43 : Closing the case
18:10 : Inserting the falcon wheel adapter
18:39 : Installing the SKF seal and putting back the wheel
20:44 : Maintenance and grease port
— THANKS FOR WATCHING —
WEBSITE : https://www.lacroixboards.com/
—- PLEASE SUBSCRIBE TO OUR CHANNEL —-
https://www.youtube.com/channel/UCUqb…
Instagram : https://www.instagram.com/lacroixboards
Facebook : https://www.facebook.com/LacroixBoards